FARGO electronic HDP600-LC manual Message, Wrong Lam Type Failed to verify the encoded mag data

RESTRICTED USE ONLY Fargo Electronics, Inc.

Reviewing LCD Messages (continued)

Message

Wrong Lam Type

Failed to verify the encoded mag data.

Cause

The installed Lamination material does not match the material required by the print job.

The card's magnetic stripe was not encoded properly.

Solution

Replace the current material with the material that is required and try again.

Check the orientation’ and coercivity of the card s magnetic stripe and press RESUME to retry encoding.

Transfer Roller Lift Error

Print Head Lift Error

The Printer is unable to move the desired part.

The Printer was unable to raise or lower the Printhead.

Verify that the part is not jammed. Press RESUME to retry. If the problem persists, call for technical assistance.

Caution: The transfer Roller may be very hot!

Verify that the head is not jammed. Press RESUME to retry. If the problem persists, call for technical assistance.

Print Timeout Error

Prox card Encoder not installed.

The Printer was unable to complete the print process.

The Proximity Card Encoder is not properly installed.

Turn the Printer OFF and ON to reset and try reprinting.

If the problem persists, call for technical assistance.

Continued on the next page

HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 4-9