FARGO electronic HDP600 CR100, HDP600-LC manual Safety Messages review carefully

To prevent equipment or media damage, refer to the following safety messages before performing an operation preceded by this symbol.

To prevent equipment or media damage, observe all established Electrostatic Discharge (ESD) procedures while handling cables in or near the Circuit Board and Printhead Assemblies.

To prevent equipment or media damage, always wear an appropriate personal grounding device (e.g., a high quality wrist strap grounded to avoid potential damage).

To prevent equipment or media damage, always remove the Ribbon and Cards from the Printer before making any repairs, unless otherwise specified.

To prevent equipment or media damage, take jewelry off of fingers and hands, as well as thoroughly clean hands to remove oil and debris before working on the Printer.

RESTRICTED USE ONLY Fargo Electronics, Inc.

Safety Messages (review carefully)

Symbol

Danger:

Caution:

Critical Instructions for Safety purposes

Failure to follow these installation guidelines can result in death or serious injury.

Information that raises potential safety issues is indicated by a warning symbol (as shown to the left).

∙To prevent personal injury, refer to the following safety messages before performing an operation preceded by this symbol.

∙To prevent personal injury, always remove the power cord prior to performing repair procedures, unless otherwise specified.

∙To prevent personal injury, make sure only qualified personnel perform these procedures.

This device is electrostatically sensitive. It may be damaged if exposed to static electricity discharges.

Information that raises potential electrostatic safety issues is indicated

by a warning symbol (as shown to the left).

∙

∙

∙

∙

∙

HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 2-2