FARGO electronic HDP600-LC, HDP600 CR100 manual Changing to the static IP address mode

RESTRICTED USE ONLY Fargo Electronics, Inc.

Changing to the static IP address mode

Step

1

2

3

4

5

6

Procedure

Select the Network link from any web page of the Printer.

Select the Use the following IP address radio button, which prepares the Printer to use network settings that the User has manually set.

These manual settings will then be used the next time the Printer is rebooted.

Enter the network settings which are required for Ethernet communications from within the same subnet.

With only these entries the User will be unable to print from a subnet other than the subnet on which the Printer is connected. These required settings are the following:

∙IP Address

∙Subnet Mask

Enter the optional network settings for Ethernet communications across a router from other subnets. The option setting is Default Gateway

Enter the optional network settings for DNS. These are the following:

∙DNS Server Address

∙DNS Domain Suffix

Select the Submit button to save these changes to stored settings in the memory of the Printer. (Note: These settings will not be lost if the power is removed from the Printer.)

HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 5-22