8.4.3.6 ROUTe:SCAN?
Returns a comma delimited list of the enabled channels.
ROUT:SCAN?
(@2,3,4)
The listo f channelsis enclosed in parenthesis and preceded with the @
symbol.
8.4.3.7 ROUTe:SCAN <chnlist>
Sets thechannels for scanning.
ROUT:SCAN2,3
The <chn list> parameter is a comma delimited list of the channels (1 to 4) to
enable. Channels that are omitted from this list are disabled. If the <chn list>
parameter is omitted, all channels are disabled. The *RST command sets chan-
nel 1 ON, and all other channels OFF.
8.4.3.8 ROUTe:SCAN:MODE? [MIN|MAX|DEF]
Returnsthe current scan mode setting.
ROUT:SCAN:MODE?MIN
0
If 0 is returned,the scan mode is simultaneous. If a 1 is returned the scan mode
is scan. Specifying the MIN parameter returns a valueof 0. Specifying the
MAX parameter returns a valueof 1 . Specifying the DEF parameter returns a
value of 1.
8.4.3.9 ROUTe:SCAN:MODE <num>|MIN|MAX|DEF
Sets the scan mode setting.
ROUT:SCAN:MODE1
The <num> specifiesthe scan mode (1 for scan, 0 for simultaneous). Spec-
ifying the MIN, MAX, or DEF parameter sets the mode to the minimum, maxi-
mum, or default,respectively. The *RST command sets scan mode to scan.
8.4.4 Probe Commands
The probe commands are used for querying, setting, and copyingthe probe
conversiontype, conversion parameters, and serial number and for testing the
temperatureconversion for a channel. The probe commands for copying and
setting parameters are password protected.
8.4.4.1 CALCulate<chn>:CONVert:CATalog?
Returns a list of conversiontypes available for the specified channel.
95
8 Digital Communications Interface
Commands