The CALCulatesuffix, <chn>, specifies the channel (1 to 4). The AVERage
suffix,<n>, specifies the calculation type. See Table 4 on page 126 for the Sta-
tistical Calculation Types.
8.4.1.3 CALCulate:AVERage<n>:TYPE?
Returnsthe keyword for the specified field type number.
CALC:AVER2:TYPE
STD
The AVERagesuffix, <n>, specifies the calculation type number.See Table 4
on page 126 for theStatistical Calculation Types.
8.4.1.4 FETCh? [<chn>]
Returns the most recent measurement for the specifiedchannel.
FETC? 1
0.0000011
or
1,2,0.0011,mV,14,5,35,2000,9,5
The <chn> parameterspecifies the channel (1 to 4). If the <chn> parameter is
omitted, the most recent measurement is returned regardlesso f the channel. If
simultaneoussampling is on, the measurement from the lowest enabled channel
number is returned. This command does not affectthe measurement action.
If the extended format setting is OFF (see Section 9.4.1.5, FORMat:STAMp
<bool>) the response isonly the measurement value in units of temperature,
volts,or ohms depending on the selected probe type or temperature unit. With
this format kohms and millivoltsare converted to ohms and volts respectively.
If the extended format setting is ON the measurement is returned in a
comma-delimited format as follows.
Measure status (0 if themeasurement has been read previously or 1 if this is a
newmeasurement,
channel number,
measurement value,
scale,
hour,
minute,
seconds,
year,
month,
89
8 Digital Communications Interface
Commands