Fluke 1529 Chub-E4

8.4.5.6 CALibrate<chn>:PARameter:OFFSet<n>? [MIN|MAX|DEF]

Returns the calibration offset parameter for the specified channel.

CAL1:PAR:OFFS2?

–1.2

The CALibratesuffix, <chn>, specifies the channel (1 to 4). This command

does notapply to memory channels. For PRT/Thermistor channels, the calibra-

tion offsetsuffix <n> specifies the resistance range parameter for PRTs (1) or

Thermistors(2). ForThermocouple channels, the calibration offset suffix <n>

is ignored and may be omitted. Note:For PRT/Thermistor channels, the value

returned by this command is always in ohms.

ForPRT/Thermistor channels, specifying the MIN parameter returns a value of

-9 when the offsetsuffix <n> is 1 (for PRTs) and -9000 when the offset suffix

<n> is 2 (for Thermistors).For Thermocouple channels, specifying the MIN

parameter returnsa value of -9. For PRT/Thermistor channels, specifying the

MAX parameter returns a valueof 9 when the offset suffix <n> is 1 (for PRTs)

and 9000 when the offsetsuffix <n> is 2 (for Thermistors). For Thermocouple

channels, specifying the MAX parameter returns a valueof 9. Specifying the

DEF parameter returns a valueof 0 .

8.4.5.7 CALibrate<chn>:PARameter:OFFSet<n> <num>|MIN|MAX|DEF

Sets the calibration offset parameter for the specified channel.

CAL1:PAR:OFFS25

The CALibratesuffix, <chn>, specifies the channel (1 to 4). This command

does notapply to memory channels. For PRT/Thermistor channels, the calibra-

tion offsetsuffix <n> specifies the resistance range parameter (in ohms) for

PRTs(1) or Thermistors (2). For Thermocouple channels, the calibration offset

suffix<n> is ignored and may be omitted. The <num> paramter specifies the

valuefor the specified offset parameter. Specifying the MIN, MAX or DEF pa-

rameter setsthe offset parameter to the minimum, maximum, or default value

respectively.

This command is password-protected. Toaccess this command, the password

must besuccessfully entered u sing theSYST:PASS:CEN <password> com-

mand (see Section9.4.11, Password Commands).

8.4.5.8 CALibrate<chn>:PARameter:SCALe<n>? [MIN|MAX|DEF]

Returns the calibration scale parameter for the specifiedchannel.

CAL1:PAR:SCAL2?

The CALibratesuffix, <chn>, specifies the channel (1 to 4). This command

does notapply to memory channels. For PRT/Thermistor channels, the calibra-

tion scalesuffix <n> specifies the resistance range parameter for PRTs (1) or

101

8 Digital Communications Interface

Commands