Configuring the FortiLog unit

Setting up the FortiLog unit

 

 

6Type admin in the Name field and select Login.

After connecting to the Web-based manager, you can configure the FortiLog unit IP address, DNS server IP address, and default gateway to connect the FortiLog unit to the network.

To configure the FortiLog unit using the web-based manager

1In the web-based manager, go to System > Config > Network.

2Enter the IP address, netmask, primary DNS server IP address, secondary DNS server IP address (optional), and the default gateway IP address if the FortiLog unit connects to the Internet.

Using the command line interface

You can use a terminal emulation software to connect to the command line interface (CLI) from any network that is connected to the FortiLog unit, including the Internet. This applies to all FortiLog models.

You can also access the FortiLog-800 CLI by using the null-modem cable provided to connect to the unit’s console port.

The CLI supports the same configuration and monitoring functionality as the web-based manager. In addition, you can use the CLI for advanced configuration options that are not available from the web-based manager.

To connect to the FortiLog-800 unit

1Use a null modem cable to connect the FortiLog-800 serial port to the management computer serial port.

2Start a terminal emulation program (such as HyperTerminal) on the management computer. Use these settings:

Baud Rate (bps) 9600

Data bits 8,

Parity None

Stop bits 1

Flow Control None.

3At the login: prompt, type admin and press Enter twice.

4(The login prompt is preceded by the server IP address.)

After connecting to the CLI, you can configure the FortiLog-800 unit IP address, DNS server IP address, and default gateway to connect the FortiLog-800 unit to the network.

To configure the FortiLog unit using the CLI

1Set the IP address and netmask of the LAN interface:

set system interface port1 mode static ip <IP_address> <netmask>

2Confirm that the address is correct: get system interface

20

05-16000-0082-20050115

Fortinet Inc.

Page 20
Image 20
Fortinet FortiLog-400 manual Using the command line interface, To configure the FortiLog unit using the web-based manager