Fortinet FortiLog-400, FortiLog-100 manual Selecting report result parameters, Selecting plug-ins

Vulnerability reports Reports

3Set the following:

•“Selecting report result parameters” on page 68

•“Selecting plug-ins” on page 68

•“Selecting the scan targets for the report” on page 69

•“Choosing the report destination and format” on page 71.

4Select Run now.

Selecting report result parameters

Report results parameters define how the FortiLog unit displays the vulnerability report results. Report results parameters include:

•the specific device or all device logs submitted to the FortiLog unit.

•the device IP addresses or alias names.

Figure 37: Vulnerability report parameters

To define report result parameters

1Go to Reports > Config > Vulnerabilities.

2Select new.

3Enter a report name and select OK.

4Configure the following options:

For all devices Select to generate the report for all devices.

Per device

Resolve Host Names

Resolve Service Names

Select to generate a separate report for each device.

Select to display host names by name rather than IP addresses. For details on configuring IP address host names see “Defining IP aliases” on page 55.

Select to display network service names rather than port numbers. For example, HTTP rather than port 80.

5Select Apply.

Selecting plug-ins

Select the port scans the FortiLog unit will perform on the selected device(s).

68 05-16000-0082-20050115 Fortinet Inc.