Fortinet FortiLog-100, FortiLog-800, FortiLog-400 manual 105

FortiLog CLI reference CLI commands

Table 11: set system command architecture

set system

			ping <return>
			https <return>
		denyaccess	ssh <return>
			snmp <return>
			http <return>
			telnet <return>
		wins <xxx.xxx.xxx.xxx>
		<return>
		macaddr
		{xxx.xxx.xxx.xxx
		factorydefault} <return>
		log {enable disable}
		<return>
		mtu <mtu_integer>
		<return>
		speed <speed_str>
		<return>
		status {down up}
	config	<return>
interface		secip <xxx.xxx.xxx.xxx>	<xxx.xxx.xxx.xxx>
<intf_str>		(secondary interface ip)	(netmask of secondary
			ip) <return>
			ping <return>
			https <return>
		secallowaccess	ssh <return>
			snmp <return>
			http <return>
			telnet <return>
			ping <return>
			https <return>
		secdenyaccess	ssh <return>
			snmp <return>
			http <return>
			telnet <return>
		stp-passthrough
		{enable disable}
	mode	static	ip <xxx.xxx.xxx.xxx>	<xxx.xxx.xxx.xxx>
			(interface ip)	(ip netmask)
				<return>
	port	timeout <timeout_int>
session_ttl	<port_num><return>
	default <default_val>
mainregpage	hide <return>
	show <return>

FortiLog Administration Guide 05-16000-0082-20050115 105