Status

Managing the FortiLog unit

 

 

The FortiLog unit saves the backup firmware image and restarts. When the FortiLog unit restarts it is running the previously installed firmware version.

Switching to a backup firmware image

Use this procedure to switch the FortiLog unit to operating with a backup firmware image that you previously installed. When you switch the FortiLog unit to the backup firmware image, the FortiLog unit operates using the configuration that was saved with that firmware image.

If you install a new backup image from a reboot, the configuration saved with this firmware image is the factory default configuration. If you use the procedure “Switching to the default firmware image” on page 38 to switch to a backup firmware image that was previously running as the default firmware image, the configuration saved with this firmware image is restored.

To switch to the backup firmware image

1For all three FortiLog models, use a terminal emulation software to access the unit’s CLI.

For the FortiLog-800 unit, you can also access the unit’s CLI by connecting the null-modem cable provided to the unit’s console port.

2Enter the following command to restart the FortiLog unit: execute reboot

As the FortiLog unit starts, a series of system startup messages are displayed. When the following message appears:

Press any key to enter configuration menu.....

3Immediately press any key to interrupt the system startup.

Note: You have only 3 seconds to press any key. If you do not press a key soon enough, the

FortiLog unit reboots and you must log in and repeat the execute reboot command.

If you successfully interrupt the startup process, the following message appears:

[G]: Get firmware image from TFTP server.

[F]: Format boot device.

[B]: Boot with backup firmware and set as default.

[Q]: Quit menu and continue to boot with default firmware.

[H]: Display this list of options.

Enter G,F,B,Q,or H:

4Type B to load the backup firmware image.

The FortiLog unit loads the backup firmware image and restarts. When the FortiLog unit restarts, it is running the backup firmware version and the configuration is set to factory default.

Switching to the default firmware image

Use this procedure to switch the FortiLog unit to operating with the backup firmware image that had been running as the default firmware image. When you switch to this backup firmware image, the configuration saved with this firmware image is restored.

38

05-16000-0082-20050115

Fortinet Inc.

Page 38
Image 38
Fortinet FortiLog-400, FortiLog-100 manual Switching to a backup firmware image, Switching to the default firmware image