Fostex MR-8HD owner manual Bouncing the desired part of a song

MR-8HD Owner’s Manual (Track bouncing)

Bouncing the desired part of a song

Typically, bouncing is executed from the beginning to the end of a song, as shown in Figure 1 below. However, you can bounce only the desired part by using the track bouncing and punch in/out functions together. The following assumes that the song you are going to execute track bouncing is loaded and you finished rehearsal of track bouncing.

The following procedure shows the example of bouncing the desired part of a song in the "Bounce 1-6 > 7/8" mode (<Note>: In the “1-8 > NEW SONG” mode, you cannot bounce the desired part of a song by using the track bouncing and auto punch in/out functions together).

Typical bouncing (Fig. 1)

Bouncing the desired part (Fig. 2)

ABS ZERO

TRK 1

TRK 2

TRK 3

TRK 4

TRK 5

TRK 6

TRK 7

TRK 8

REC END

Mixing

Punch in point	Punch out point
(=LOCATE A point)	(=LOCATE B point)

TRK 1
TRK 2	Mixing
TRK 3
TRK 4
TRK 5
TRK 6
TRK 7
TRK 8

1)	Set the punch-in and punch-out points (see page		5)	Press the [RECORD] key while holding down the
	54).			[PLAY] key.
	By pressing the [PLAY] key while holding down			The "			" icon is shown and the recorder
	the [STOP] key, you can play back the part			starts playback. It automatically starts
	between the punch-in and punch-out points			recording (bouncing) when it reaches the
	(see page 44).			punch-in point.
2)	Locate the recorder to a position before the					Punch-in point		Punch-out point
					(=LOCATE A point)			(=LOCATE	B point)
	punch-in point.			TRK 1
3)	Press the [1-4>5/6, 1-6>7/8] key to set the bounce
				TRK 2
	mode to "1-6>7/8".			TRK 3
	When setting the bounce mode to "1-6>7/8",			TRK 4
	tracks 7/8 automatically enter the input			TRK 5
	monitor mode and "	" lights on the		TRK 6
	home screen.			TRK 7
				TRK 8

Lighting	Playback	Recording	Playback
	(Input monitor)	(track bouncing)

					The recorder stops recording (bouncing) at the
				Lighting	punch-out point and returns to playback, while
					the auto punch mode exits and "	" in
			Flashing		the screen turns off.
4)	Press the [AUTO PUNCH] key to activate the auto				<Note>: During playback in the operation
					above, you cannot monitor the sound. You
	punch mode.
					can monitor the sound (bounced sound)
	When the auto punch mode is active,
					only during recording between punch-in and
	"	" lights on the home screen.
					punch-out points.

6) Press the [STOP] key to stop the recorder.

Lighting

Check the result by playing back the bounced tracks, as described earlier.

<Note>: If you are not satisfied with the re- sult, press the [UNDO/REDO] key to redo the operation.

74