3.8Turning OFF the Power

ON LINE

DATA

Power Switch

ON LINE

DATA

To turn the power switch to OFF (), follow the steps below.

1.Make sure that LED lamps 1 to 10 on the transfer monitor are off.

IMPORTANT:

If any of the LED lamps (1 to 10) on the transfer monitor is on, wait until all receivers are discharged.

If the power switch is set to OFF () during this time, the paper stops inside the machine and a jam error occurs the next time the power switch is set to ON.

If a power failure, inadvertent power OFF, or power plug

disconnection occurs during printing, set the power switch to ON () again, check inside the machine and

remove any paper remaining in the transfer section.

2.Set the power switch to OFF ().

IMPORTANT:

Do not turn the power switch ON and OFF in short intervals since this may cause the machine to malfunction.

While the power switch is turned OFF (), do not open the inner door because the donor may be exposed to extraneous light, which could result in abnormal print production.

If the machine is not to be used for period longer than one week, remove the donor and receiver magazines from the machine and store them in a cool dark place, and empty the water bottle.

3.Make sure that all the lamps on the operation panel are off.

NOTE: Use care when disconnecting the power plug.

3

OPERATING PROCDURES

WARNING:

Do not touch the power plug with wet hands as this may result in an electrical shock.

CAUTION:

When disconnecting the power plug, always hold the plug. Pulling the power cable may expose the conductor or snap the wires, which may cause a fire or electrical shock.

41

Page 50
Image 50
FujiFilm 4500N instruction manual Turning OFF the Power