6.1 Clearing Donor/Receiver Jams

Transfer display

Coutermeasure

 

 

 

Remove the magazine. Pull out the donor's leading edge about 2 cm and insert the

 

 

 

magazine again.

 

 

 

IMPORTANT: If the leading edge is torn or bent, cut off the torn or bent portion with

 

D

(+1)

 

scissors or the like.

 

 

(+6)

If the donor magazine cannot be pulled out, pull the “J12” knob

 

R

 

(manual cutter) out and in to cut off the donor, pull out the magazine,

 

 

 

and close the cover. The remaining paper is discharged into the donor

 

 

 

 

 

 

insertion section.

2Rotate the "J1" knob in the direction indicated by the arrow. Open the left-hand upper side door and open the "J2" guide.

3Open the thermal processing unit with "J11", and then open the right-hand side upper door.

Rotate the "J3" knob in the direction indicated by the arrow.

4Open the thermal processing unit with "J11" and rotate the "J4" knob in the direction indicated by the arrow.

Pull out the refuse compartment and open its top section.

Pull out the leading edge from the lower side of the thermal processing unit.

5Rotate the "J5" knob in the direction indicated by the arrow.

7Open the thermal processing unit with "J11", and then open the right-hand side upper door.

Rotate the "J7" knob in the direction indicated by the arrow.

8Open the thermal processing unit with "J11" and then open the right-hand side upper door.

Open the "J8" guide.

9Pull out the refuse compartment and open its top section. Open the "J9" guide.

10Open the left-hand side lower door and open the "J10" guide.

WARNING: If donor/receiver jamming is accompanied by the emission of smoke, immedi- ately turn the power switch to OFF (), disconnect the power plug from the power outlet, and contact your dealer.

IMPORTANT: When removing a jammed donor or receiver, use care not to tear it. If you do, be sure to remove all the pieces of donor/receiver from the machine.

After clearing a jam, properly close the doors. If you don't, the machine will not become enabled for printing. If the doors are left open for an extended periods, dust may enter the machine, or the donor may be exposed.

Do not open the inner door unless necessary. Opening the inner door exposes the donor's leading end to extraneous light.

If the donor magazine is removed during donor/receiver jam clearing, the exposed portion of the donor's leading end will be automatically cut off and discharged after the jam is cleared.

6

DONOR/RECEIVER JAM CLEARING PROCEDURES

93

Page 102
Image 102
FujiFilm 4500N instruction manual DONOR/RECEIVER JAM Clearing Procedures