102
5
.Adjust the donor so that about 0.8 in. (2 cm) protrudes
from the receiver magazine.
●Cut the leading end square. Make sure that the width of
the protruding end does not vary by more than 0.12 in.
(3 mm).
●Use care so that the receiver's leading end does not
slip back into the receiver magazine. If it does, it will be
impossible to pull out the receiver.
6
.Close the left-hand side upper door. Grasp the receiver
leading end and slowly insert the receiver magazine along
the guide.
IMPORTANT:
If the magazine is inserted with the donor's leading end bent,
the machine may multifunction.
NOTE: Push the receiver magazine all the way in.
7
.Close the front upper door.
★The machine will automatically cut off and discharge
the unusable portion of the receiver's leading end.
IMPORTANT:
●Do not open the door during the receiver discharge
process. Receiver jamming may occur.
●Do not turn the power switch to OFF ( ) or disconnect
the power plug during the receiver discharge process.
Receiver jamming may occur.
6.5 Jamming at Location "6"
0.8 in.
(2 cm)