3.5Receiver Magazine Replacement
●There is a receiver end detection hole on the trailing edge of the receiver. When this hole is detected by the machine, the receiver's trailing edge is discharged as described below.
●Replace the receiver magazine when the R LED on the transfer monitor comes on.
NOTE: If the donor or receiver magazine is left in a room or in a hot and damp place for a long time, print quality deterioration may result. Store the magazines in a cool dark place away from direct sunlight. When stored for over a month, keep them at 10°C, 60%RH or less.
●After replacing the receiver, replace the water (see Section 3.6) and dispose of the refuse (see Section 3.7).
Paper End Process
Warning
Donor Empty
Receiver
Magazine
Front Upper Door
■The trailing edge discharge
★When the receiver is used up, the message changes to "End Process" and the receiver trailing end is discharged after about 3 minutes.
★When the discharge is completed, the message changes to "Warning Paper Empty", the R LED lamp on the transfer monitor comes on, and the alarm sounds (four successive short beeps, repeated).
Replace the receiver magazine by doing the procedure below.
1.Make sure that LED lamps 1 to 10 on the transfer monitor are off. Open the front upper door and pull the receiver magazine straight out.
IMPORTANT:
Do not open any door while LED lamps 1 to 10 on the transfer monitor is on. If you do, donor/receiver jamming may occur.
2.Unlock both sides of the receiver magazine and open the cover of the magazine.
32
