
4.13Calibration (Standard Color Condition Setup)
The printer itself can be adjusted to provide consistent prints. Perform a calibration (standard color condition setup) whenever the donor is changed, or within one month after the last calibration. To calibrate (setup standard color conditions), follow the procedure given below:
PREV
ESCSEL
NEXT
Calibration
PREV
ESCSEL
NEXT
Print Reference
1.Press the [ON LINE] key on the operation panel to place the machine in the OFF LINE mode.
2.key.Once the OFF LINE mode is activated, press the [NEXT]
★The message changes to "Calibration".
■Creation of the calibration pattern
1.Press the [SEL] key.
★ The message changes to "Print Reference".
2.
Imaging
3.
Press the [ ] key.
★The message changes to "Imaging", and the machine begins loading the calibration pattern data.
As print processing gets underway following loading of the calibration pattern, the message changes to "Processing".
Remove the calibration pattern from the print tray.
★The message indication will alternate repeatedly between "Measure Density" and "Cancel".
Print Tray
Measure Density
Cancel
62