3.4 Donor Magazine Replacement

0.8in. (2 cm)

9.Remove the tape securing the black light-blocking leader and pull out the edge of the film about 0.8 in. (2 cm) from the donor magazine. Then close the cover and lock both sides.

10.Make sure that the dip switch on the donor magazine is set as follows.

1 2 3

OFF

1 2 3

ON

Tape

Black Light Blocking Leader

11.Pull out the black light-blocking leader slowly until the edge of the donor comes out.

IMPORTANT:

After inserting the donor into the donor magazine, install the magazine immediately into the machine. If the maga- zine is left in a bright place for a long time, the donor in the magazine may be exposed to extraneous light.

12.After pulling the donor end out, slowly remove the tape securing the light-blocking leader slowly.

13.Remove the light-blocking leader slowly.

0.8 in.

(2 cm)

IMPORTANT:

If the donor edge is cut or bent, a donor/receiver jam may occur. Cut the end of the donor with scissors or the like.

NOTE: Cut the leading end square so that the about 0.8 in. (2 cm) of the donor's leading end protrudes from the donor magazine. Make sure that the front-to-rear protrusion differential is not greater than 0.12 in. (3 mm).

30

Page 39
Image 39
FujiFilm 4500N instruction manual Off