
4.15Network Setting
The following is an explanation of network setting.
There are 2 methods of setting the network as shown below.
●Set it by using the operation panel of PG4500N.
●Set it by installing the setting software on the connected host (PC).
4.15.1Setting Using the Operation Panel
PREV
ESCSEL
NEXT
Network Setting
| PREV |
|
| ESC | SEL |
| NEXT |
|
Password |
| ] |
] | 0000 | |
– | + | |
[ |
| [ |
Failed Verify
the Password
|
| PREV |
|
|
| ESC | SEL |
|
| NEXT |
|
| ] |
| ] |
TCP/IP | – | Enable | + |
[ | [ |
1.
2.When the machine is in OFFLINE mode, press the NEXT key four times.
★The message changes to "Network Setting".
3.Press the SEL key.
★When the password is set, go to Procedure 4, and when it is not set, go to Procedure 5.
4.Input the set password.
★If the password is not correct, a "Failed to verify the Password" message appears, so press the [ESC] key and redo from Procedure 2.
5.Screen for setting TCP/IP opens. In the case of "Enable", go to Procedure 5, and in the case of "Disable", go to Procedure 13.
TCP/IP
] – [
Disable
] + [
68