Fujitsu BX600 manual Start up and Configuration the IBP Module, Port Default Settings

Start up and Configuration the IBP Module Configuration the IBP Module

5.3 Start up and Configuration the IBP Module

It’s important to understand the IBP Module architecture when configuring the IBP Module. The IBP Module has two types of ports. One type is for interfacing the IBP Module with PRIMERGY BX600 Blade Server, and the other type are regular Ethernet ports used for connecting PRIMERGY BX600 Blade Server to the network.

The IBP Module module is connected to PRIMERGY BX600 Blade Server (Management Board) MMB through 30 internal ports called the Internal Ports. The maximum link speed through the Internal Ports is 1 Gigabit per port. The port configuration ID’s are g1 to g30. To connect the IBP Module to the network there are 12 PHY based ports called the External ports. The external 12 ports are 10/100/1000 Base-T Ethernet ports. The port configuration ID’s are g31 to g42.

The default configuration of the internal and external ports are as follows:

Table 4-1. Port Default Settings

Figure 4-1. Installation and Configuration Flow

36 Intelligent Blade Panel Module