Panel Settings Menu

Web-Based Management Interface

new values across a power cycle, you must perform a save.

Configuring SNMP Trap Receiver Configuration Page

This menu will display an entry for every active Trap Receiver.

Configurable Data

SNMP Community Name - Enter the community string for the SNMP trap packet to be sent to the trap manager. This may be up to 16 characters and is case sensitive.

SNMP Version - Select the trap version to be used by the receiver from the pull down menu:

SNMP v1 - Uses SNMP v1 to send traps to the receiver.

SNMP v2 - Uses SNMP v2 to send traps to the receiver.

IP Address - Enter the IP address to receive SNMP traps from this device. Enter 4 numbers between 0 and 255 separated by periods.

Status - Select the receiver's status from the pulldown menu: Enable - send traps to the receiver.

Disable - do not send traps to the receiver.

Command Buttons

Submit - Update the IBP with the values on this screen. If you want the IBP to retain the new values across a power cycle, you must perform a save.

Delete - Delete the currently selected Community Name. If you want the IBP to retain the new values across a power cycle, you must perform a save.

73

Intelligent Blade Panel Module

 

Page 74
Image 74
Fujitsu BX600 manual Configuring Snmp Trap Receiver Configuration