Booting Device |
| Configuration the IBP Module |
2.Power up the Chassis and observe booting information (if Chassis is running press <Enter> few times to ensure that terminal connection is successful).
5.5 Booting Device
•The device is delivered with a default configuration.
•The device is not configured with a default user name and password.
After connecting the PRIMERGY BX600 Blade Server serial port to the IBP Module,
When the IBP Module is connected to the local terminal, the device IBP Module goes through Power On Self Test (POST). POST runs every time the device is initialized and checks hardware components to determine if the device is fully operational before completely booting. If a critical problem is detected, the program flow stops. If POST passes successfully, a valid executable image is loaded into RAM. POST messages are displayed on the terminal and indicate test success or failure.
As the device boots, the bootup test first counts the device memory availability and then continues to boot. The following screen is an example of the displayed POST:
System SDRAM Test..........…………….........PASS
CPU Self Test......................………………….PASS
UART Loopback Test.................……………..PASS
Flash Memory Initialize............……………….PASS
Flash Memory Checksum Test.........………...PASS
PCI Bus Initialize and Test........………………PASS
System Timer Test..................………………..PASS
The boot process runs approximately 60 seconds.
The
38 | Intelligent Blade Panel Module |
