Fujitsu TX300 manual Laser information, ESD label

Safety instructions

I You can prevent damage from the optical drive and the CDs/DVDs/BDs, as well as premature wear of the disks, by observing the following suggestions:

–Only insert disks in the drive when needed and remove them after use.

–Store the disks in suitable sleeves.

–Protect the disks from exposure to heat and direct sunlight.

Laser information

The optical drive complies with IEC 60825-1 laser class 1.

VCAUTION!

The optical drive contains a light-emitting diode (LED), which under certain circumstances produces a laser beam stronger than laser class 1. Looking directly at this beam is dangerous.

Never remove parts of the optical drive casing!

Modules with Electrostatic-Sensitive Devices

Modules with electrostatic-sensitive devices are identified by the following sticker:

Figure 1: ESD label

When you handle components fitted with ESDs, you must always observe the following points:

●Switch off the system and remove the power plugs from the power outlets before installing or removing components with ESDs.

●You must always discharge static build-up (e.g. by touching a grounded object) before working with such components.

●Any devices or tools that are used must be free of electrostatic charge.

TX300 S6 Options Guide 25