Fujitsu TX300 Accessible drives and LSD/LSP, Detaching the EasyClick rails from the dummy cover

Accessible drives and LSD/LSP Accessible 5.25-inch drive

Figure 27: Detaching the EasyClick rails from the dummy cover

ÊDetach the EasyClick rails from the dummy cover by removing the four screws on each side.

I Note that there are two M3 x 4.5mm screws with M3 thread (yellow ellipse) and two 6-32 x 4.8mm screws with UNC thread (blue ellipse) on each side.

V CAUTION!

Keep the dummy cover for future use. If you remove the accessible drive again and do not replace it with a new one, the dummy cover must be reinstalled to comply with EMC regulations and to satisfy cooling requirements and fire protection measures.

TX300 S6 Options Guide 57