10. Selecting the Job Functions
Memory Recall
After a print cycle has been completed, Memory Recall allows you to run another print cycle again using the same image data and copy settings as the previous one without having to reload the originals.
After the first print cycle, touch Memory Recall on the Touch Panel to show a screen that allows you to make the necessary settings.
Making Copies Chapter 3
Setting Memory Recall
1 Touch Memory Recall .
| 1155O385CC |
2 | If you have any function to change, touch the |
| corresponding mode key and make the |
necessary change.
1155O386CA
Useful Tips
•The following functions can be changed when running a print cycle again using Memory
Recall: |
|
•Finishing | •Orig. ▼Copy |
•Paper | •Date |
•Page | •Distribution # |
•Image Stamping | •No. of copies |
• A pen mark 
appears above the key of the function changed.
• To change the number of copies to be made,
press the C key and set the new number.
• Paper size and direction cannot be changed.
3 | Press the Start key and the copier starts the |
| print cycle. |
NOTES
•Memory Recall available from User's Choice must be turned ON to use this function.
☞p.
•This function cannot be used in the Interrupt mode.
•The preceding image data and copy settings are cleared to disable Memory Recall when any of the following operations are performed:
-The copier is turned OFF.
-The copier scans a new original or the Start key is pressed.
-The Access key or Interrupt key is pressed,
or Reserve is touched.
- The C key or Panel Reset key is pressed while the copier remains idle.
Useful Tip
After you have made copies from a confidential document, it is recommended that you press the Panel Reset key to erase the data.
