Installation

Note The DVR is not supplied with a modem cable, and many modems are not supplied with cables. Make certain you have the correct cable when purchasing the modem.

Factory Reset

Figure 2-10 Factory Reset Switch

RS - 232C

Factory reset switch

The DVR has a Factory Reset switch to the right of the RS232C connector. This switch will only be used on the rare occasions that you want to return all the settings to the original factory default settings.

Caution When using the Factory Reset, you will lose any settings you have made.

Caution If you wish to use the same DVR name registered on the DVRNS server after initializing the system using the factory reset, you need to contact the DVRNS server manager. Please record and save the help desk information before performing a factory reset.

To reset the unit, you need a straightened paper clip:

1.Turn the DVR off.

2.Turn it on again.

3.While the DVR is initializing, poke a straightened paper clip in the unlabeled hole to the right of the USB port.

4.Hold the switch until all the LEDs on the front panel are lit.

Rev 3.03

11

Document 900.0315

 

 

02/07