Configuration
8.Highlight the box beside Line Delimiter and press . In the virtual keyboard, enter the character(s) that the device uses to indicate the end of a line. Control characters can be created using ^and a capital letter (for example, ^J for NL [New Line], ^M for CR [Carriage Return]). Refer to the device manufacturer’s documentation for Line Delimiter character(s).
9.Highlight the box beside Ignore String and then press . Use the virtual keyboard to enter any strings of text that you want the DVR to ignore. Reer to the device manufacturer’s documentation for text strings that the device sends during transactions, so you will know which ones you do not want recorded.
Note When setting up the
10.Highlight the box beside Transaction Timeout, and set the length of time to wait for the new text string. The DVR will consider a transaction ended if there is no text sting during timeout dwell time after the last text input string. You can adjust the timeout dwell from 0 to 300 seconds.
11.Highlight the box beside Display Dwell, and set the length of time you would like to display
12.Highlight the Case Sensitive box and then press the to toggle between On and Off. Refer to the device manufacturer’s documentation to determine if the text strings are Case Sensitive. If the device distinguishes between upper and lower case letters, make certain the Case Sensitive box is turned On.
Alarm Out Setup Screen
Use the Alarm Out setup screen to establish a schedule for each alarm output from the DVR. Highlight Alarm Out from the Device menu (MENU ➤ Device ➤
Figure
Rev 3.03 | 40 | Document 900.0315 |
|
| 02/07 |