Configuration
1.Highlight the box under the On/Off heading and then press . This toggles between On and Off.
When it is On, the DVR reports a fault condition if it does not detect any recording or if there is no alarm during the designated time.
2.Highlight the box under the Interval heading and then press . A slide bar displays allowing you to set the check interval from 1 Hour to 30 Days by using the Left and Right Arrow buttons.
3.The Status field displays the fault conditions.
Good means that there was recording or an alarm occurred during the designated time.
Bad indicates that there was no recording or no alarm occurred during the designated time.
4.Highlight the Alarm Out / Notify tab and the System Check - Alarm Out / Notify screen displays.
Figure
5.Highlight the box under the Alarm Out heading and press . A drop menu displays available alarm outputs for the recording problem.
6.Highlight the desired alarm output from the external alarm out terminal or internal buzzer, and press .
Note | Alarm Out cannot be set to Check Point System. |
|
|
7.Highlight the box under Notify and press . This toggles between On and Off. When it is On, the DVR notifies the remote site of its System (Good) and Record (Bad).
Rev 3.03 | 30 | Document 900.0315 |
|
| 02/07 |