Configuration
Note When using the NAT device, refer to the NAT manufacturer’s instructions for the appropriate network settings.
5.Highlight the box beside DVR Name and then press to name the DVR to be registered on the DVRNS server. A virtual keyboard allows you to enter the DVR name.
6.Selecting Check allows you to check whether or not the name you entered can be used.
Note The DVR name you entered should be checked by selecting
Name Check; otherwise, the DVRNS changes will not be saved.
When entering no name or a name already registered on the
DVRNS server, an error message displays.
7.Highlight OK and then press to register the DVR on the DVRNS server. Proper DVRNS settings display the help desk information of the DVRNS server in the box beside Help Desk.
Caution If you want to use the same DVR name registered on the DVRNS server after initializing the system using the factory reset, you need to contact the DVRNS server manager. Please record and save the help desk information before performing a factory reset.
The DVRNS registration is limited to one DVRNS server. The DVR cannot be registered to multiple DVRNS servers. Please contact your network administrator when you want to register the DVR to another DVRNS server.
Callback Center Setup Screen
You can set up the DVR to contact a computer running RAS (Remote Administration System) on a LAN when an event occurs. You can also set it up to dial a pager with a numeric message when an event occurs if you have a modem connected to the DVR.
Rev 3.03 | 67 | Document 900.0315 |
|
| 02/07 |