3.Press 4ESC5 at the prompt for stopping the boot selection process.

4.You will see the follo wing messages:

Terminating selection process.

...

Searching for potential boot devices.

To terminate search, press and hold the ESCAPE key.

Device Selection Device Path Device Type and Utilities

------------------------------------------------------------

Your system searc hes for devices that ma y hold an alternate HP-UX. As the devices are found, they appear in a list, suc h as the following example:

P0

scsi.6.0

QUANTUM PD210s

 

P1

scsi.5.0

QUANTUM PDS210s

 

P2

scsi.2.0

TOSHIBA CD-ROM DRIVE:XM

 

P3

lan.123456-789abc

homebase

 

This process ma y take several minutes. You can terminate the searc h at any

6

time by pressing 4ESC5.

 

 

5.If two devices are set to the same SCSI bus address, the searc h terminates when it ￿nds the duplicate. If this happens, y ou must change the SCSI bus address of one of the devices. (Use the Installation Guide for the device to guide you in changing its jumper or switc h settings.)

6.If you are running a disk ed system and no disk devices are found, then y ou may have a hardware installation problem. In this case, y ou should recheck the connection to the SCSI devices and try the boot again. If this still results in no devices being listed, con tact your HP service represen tative for assistance.

7.A successful searc h will result in the follo wing list of possible actions being displayed:

b)Boot from specified device

s) Search for bootable devices

Dealing With Problems 6-7

FINAL TRIM SIZE : 7.0 in x 8.5 in