The steps for adding a DDS tape driv e to your system are:
1.Make sure that the necessary device driv ers are congured in to the kernel. SAM will mak e this test.
2.Shut you system down and turn o the po wer.
3.Choose a SCSI bus address for the new tape driv e that does not matc h the bus address for an y other SCSI device.
4.Make all necessary hardw are connections for the device.
5.Turn the new tape driv e on .
46. Turn your system on.
7. Run SAM to create the device les for the new tape driv e.
The
SCSI bus address: 3
As it is possible that the SCSI bus address jumpers for a driv e may be shipped with dierent settings, please c heck the settings before installing the device. See the Installation Guide for the device for information on resetting it, should it be necessary.
Configuring the Drive on
The SAM Kernel Configuration procedure will conrm whic h drivers are active for your tape devices and will congure them as needed, for connected devices. Reconguring the k ernel will involve rebooting your system.
FINAL TRIM SIZE : 7.0 in x 8.5 in