5.Identify the existing RAM boards b y their part numbers:

a.98236-66522; 4 MB board.

b.98236-66524; 8 MB board.

c.A2576-60001; 16 MB board.

d.A2575-60001; 32 MB board.

6.Spread the clips holding one of the RAM boards in place,

7.Raise the RAM board to and angle of 45 ￿ With your ￿ngers near the middle of the raised edge of the board, pull it gen tly away from you until it is free.

8.Repeat this for the other RAM board.

To insert one new board of the pair y ou are replacing:

1.

Note the RAM board is notc hed at one end to ￿t the k eyed connector.

 

2.

Place the ￿rst RAM board y ou will install in an empt y slot with the labelled

 

 

side up, the notch to your left and the con tacts facing y ou. Avoid touching

 

 

the RAM board contacts.

 

3.

Holding the board at the outer (non-con tact) edge with the label side up,

 

 

place it in one of the memory RAM slots at a 45 ￿ angle to the system

 

 

board.

 

4.

Snap the RAM board in place b y moving it to the horizon tal. Its ends will

 

 

snap into the slot's spring clips.

 

5.

Install the second RAM board.

 

6.

Re-install the system module in the w orkstation or cardcage b y pushing it

A

 

back into its slot until it snaps in place.

 

 

Replace the four screws in the Model 742i fron t panel.

Installing Additional Memory A-5

FINAL TRIM SIZE : 7.0 in x 8.5 in