NOTE: You can also view the IP address in the EWS or HP ToolboxFX by selecting the Advanced Network Settings tab.

IPv4 and IPv6 settings

Only the IPv4 protocol can be configured manually. The IPv4 protocol can be set from HP ToolboxFX or from the product control panel. The IPv6 protocol can be selected only from the product control panel.

Link speed setting

NOTE: Incorrect changes to the link speed setting might prevent the product from communicating with other network devices. For most situations, the product should be left in automatic mode. Changes can cause the product to power cycle. Changes should be made only while the product is idle.

1.On the control panel, press Setup.

2.Use the arrow buttons to select Network configuration, and then press OK.

3.Use the arrow buttons to select Link speed, and then press OK.

4.Use the arrow buttons to select one of the following settings.

Automatic

10T Full

10T Half

100TX Full

100TX Half

NOTE: The setting must match with the network product to which you are connecting (a network hub, switch, gateway, router, or computer).

5.Press OK. The product will power cycle.

ENWW

Configure the network product (HP LaserJet CM1312 (fax/photo-card model) only) 51

Page 63
Image 63
HP CM1312nfi MFP manual Link speed setting, IPv4 and IPv6 settings