HP CM1312nfi MFP manual Print quality Calibrate Color Calibrate Now, After Power On, Cartridge low

Table 2-5System setup menu (continued)

Menu Item	Sub-menu item	Sub-menu item	Description
Print quality	Calibrate Color	Calibrate Now	Perform a Color Pane Registration (CPR) and density
		After Power On	calibration. Select Calibrate Now to perform an immediate
			calibration. Select After Power On to specify the minutes/
			hours the product should wait after power on to perform an
			automatic calibration (the default is 15 minutes).
	Cartridge low	(Range of 1-20)	Sets the percentage at which the control panel generates a
	threshold		low-toner message.
	Replace supplies	Stop at Out	Sets how the product reacts when it detects that the print
		Override out	cartridge has reached its estimated end of life.
			Choose Stop at Out to stop printing when the estimated end
			of life has been reached for a supply. Printing beyond this
			point is possible using Override out. The supply does not
			need to be replaced now unless the print quality is no longer
			acceptable.
			Choose Override out to allow the product to continue
			printing when supply items have reached the end of their
			estimated life. Using this option will eventually result in
			unacceptable print quality. Consider having a replacement
			cartridge available for when the print quality becomes
			unacceptable.
			Information about the remaining toner is not available when
			printing in Override out mode.
			Once an HP supply has reached the end of its estimated life,
			HP's Premium Protection Warranty on that supply has
			ended. For warranty information, see Print cartridge limited
			warranty statement on page 233.
	Color supply out	Stop printing	Sets how the product should react when it detects that a
		Continue black	color cartridge has reached its estimated end of life. Select
			Stop printing to stop all printing until the cartridge is
			replaced, or select Continue black to continue printing in
			black monochrome mode.
Adjust Alignment	Print Test Page		Print out a tray-specific sheet of instructions and a test page
(photo card models			with a border that can be used to estimate the adjustment
only)			needed to center the printed image on the page.
	Adjust Tray 1		After printing the test page, use the options in the Adjust
			Tray 1 menu to calibrate the tray. The following settings can
			be adjusted for Tray 1:
			●	X1 Shift
			●	Y Shift
Volume Settings	Alarm volume	Soft	Sets the volume levels for the product.
(photo card models
	Ring volume	Medium
only)
	Key-press volume	Loud
	Phone line volume	Off
Time/Date	(Settings for time		Sets the time and date setting for the product.
	format, current time,

date format, and current date.)

18 Chapter 2 Control panel ENWW