HP E1Z75UT E1Z75UT#ABA Troubleshooting without diagnostics, Out of memory error Cause Solution

NOTE: The memory count will be affected by configurations with the Management Engine (ME) enabled. The ME uses 8MB of system memory in single channel mode or 16MB of memory in dual- channel mode to download, decompress, and execute the ME firmware for Out-of-Band (OOB), third- party data storage, and other management functions.

System will not boot or does not function properly after installing additional memory modules.

Cause Solution

A memory module is not installed in the DIMM1 or XMM1 socket.

Ensure that a memory module is installed in the DIMM1 or XMM1 socket on the system board. This socket must be populated with a memory module.

Memory module is not the correct type or speed grade for the system or the new memory module is not seated properly.

Replace module with the correct industry-standard device for the computer. On some models, ECC and non-ECC memory modules cannot be mixed.

Out of memory error.

Cause Solution

You have run out of memory to run the application.

Check the application documentation to determine the memory requirements.

Memory count during POST is wrong.

Cause Solution

The memory modules may not be installed correctly.

Check that the memory modules have been installed correctly and that proper modules are used.

Integrated graphics may use system memory.	No action required.
Insufficient memory error during operation.
Cause	Solution
Too many Terminate and Stay Resident programs (TSRs) are	Delete any TSRs that you do not need.
installed.

You have run out of memory for the application.

Check the memory requirements for the application or add more memory to the computer.

178 Chapter 8 Troubleshooting without diagnostics