5.Connect the power cable (1) and data cable (2) to the back of the hard drive.

NOTE: The power cable for the hard drives is a three-headed cable that is routed from the system board to the rear of the hard drive bays.

6.If installing a new drive, connect the opposite end of the data cable to the appropriate system board connector.

NOTE: You must connect the primary hard drive data cable to the dark blue connector labeled SATA0 to avoid any hard drive performance problems. If you are adding a second hard drive, connect the data cable to one of the light blue SATA connectors.

66

Chapter 5 Removal and replacement procedures: Tower (TWR)

Page 76
Image 76
HP E1Z77UT E1Z77UT#ABA, E1Z74UT E1Z74UT#ABA, E1Z75UT E1Z75UT#ABA manual