Configuring a Telnet Listener

Configuring a Telnet Listener

Introduction

Perform the following steps to assign a Telnet listener to one or more devices attached to access server ports:

Step Action

1Assign a TCP port to the access server port. The access server uses 23, and 2001 to 2032 as TCP port numbers. The TCP port number is the number that users on the TCP/IP network use to connect to the device on the access server port.

2Determine which access server port or ports are to be assigned to the Telnet listener.

3Provide an identification string that helps users recognize and use the resource. It can be up to 40 characters in length. The factory-set default is no identification string.

4Enable the listener to receive connections. The factory-set default for CONNECTIONS is DISABLED.

5Specify the individual access server session characteristics, as described in the Configuring Telnet Server Session Characteristics section in this chapter.

Configuring and Managing Telnet Servers 13-11

Page 279
Image 279
HP NetRider manual Configuring a Telnet Listener, Introduction