HP NetRider Introduction, Service Groups, Viewing Service Groups, Changing Service Groups Examples, Changing Access Server Service Groups

Service Groups

Service Groups

Introduction

A service group defines the access that service nodes and port users have to the network. Each service group has an identifying number from 0 to 255.

Viewing Service Groups

To view service groups that have access to services on the access server, use the SHOW SERVER command. (See the LAT Characteristics Display Example section in this chapter.)

Changing Access Server Service Groups

Use one of the following commands:

∙To enable service groups on the access server, use the following command:

Local> CHANGE SERVER SERVICE GROUPS group-listENABLED

∙To assign ports to a service group, use the following command:

Local> CHANGE PORT port-listAUTHORIZED GROUPS group-listEN-

ABLED

Changing Service Groups Examples

∙The following example shows how to enable service groups 1, 16, and 18:

Local> CHANGE SERVER SERVICE GROUPS 1,16,18 ENABLED

∙The following example shows how to assign ports 2, 3, and 5 to service groups 1, 16, and 18:

Local> CHANGE PORT 2,3,5 AUTHORIZED GROUPS 1,16,18 ENABLED

6-18 Configuring LAT Characteristics