HP NetRider manual Modify and SET Commands, Delete Command, Example DSV$CONFIGURE ADD Command

DSV$CONFIGURE

Example: DSV$CONFIGURE ADD Command

This example shows the ADD command on a DECnet/OSI system. In this example, at the end of each line you must press return to continue.

DSV> ADD SERVER

_Server Name: DGD700

_Ethernet Address: 08-00-2B-26-AE-32

_Server Type: DS700

_Service Circuit [SVA-0]:

_Maintenance Password [none]: FEDCBA _Dump File [MOP$DUMP:DS7DGD700.DMP]:

_Load Image [MOP$LOAD:WWENG2.SYS]:

After entering the ADD command, you can display information about the MOP client with the:

∙DSV$CONFIGURE LIST command

∙NCL SHOW command for DECnet/OSI

∙NCP SHOW NODE command for DECnet Phase IV

If you use DECnet Phase IV, the required DECnet address prompt has a default of the first unused address in area 13. You no longer need to enter an external SHOW NODE 13.* command prior to adding an access server.

MODIFY and SET Commands

The MODIFY and SET commands operate in a manner similar to the ADD command. These commands provide defaults for each prompt. The defaults are the existing values for the server.

The syntax, prompts, and displays for the SET and MODIFY commands are similar to those for the ADD command.

DELETE Command

The DELETE command removes an access server. This command clears both the permanent configuration data stored on disk and the operational data stored in memory.

The syntax of the DELETE command is identical to that for the ADD command.

Managing Load Hosts 4-5