DSV$CONFIGURE

Example: DELETE Command for DSV$CONFIGURE

The following example shows the DELETE command. This example omits the optional SERVER keyword. In this example, NCL displays the message NODE 0 MOP Client DGD700 on a DECnet/OSI system. NCP displays a similar message on a DECnet Phase IV system.

DSV> DELETE DGD700

 

 

Server:

DGD700

Circuit:

SVA-0

Address:

08-00-2B-26-AE-32

Maint. Password:

FEDCBA

Type:

DS700

 

 

Dump File:

MOP$DUMP:DS7DGD700.DMP

 

Image File:

MOP$LOAD:WWENG2.SYS

 

 

Are you SURE you want to delete this server??? [No]: YES

Node 0 MOP Client DGD700 at 1992-10-26-13:31:29.378-05:00I0.176

LIST and SHOW Commands

The LIST and SHOW commands display information about an access server. The syntax of the LIST command is identical to that for the ADD command with one exception: server-namecan be a wildcard character.

Example: LIST Command for DSV$CONFIGURE

The following example shows the data that the LIST and SHOW commands display. In this example, the DECnet address would also display if this were a DECnet Phase IV node.

DSV> LIST SERVER

 

 

 

_Server Name:

DGD700

 

 

Server:

DGD700

Circuit:

SVA-0

Address:

08-00-2B-26-AE-32

Maint. Password:

FEDCBA

Type:

DS700

 

 

Dump File:

MOP$DUMP:DS7DGD700.DMP

 

Image File:

MOP$LOAD:WWENG2.SYS

 

 

CONNECT and USE Commands

The CONNECT and USE commands enable you to communicate with the remote console port on the access server. DSV$CONFIGURE uses CCR to make the connection. Once DSV$CONFIGURE makes the connection, you can use most any access server command supported at any physical port.

4-6 Managing Load Hosts