Specifying DTRWAIT
Specifying DTRWAITDescription
When functioning with modems and computer interfaces, the access server port normally asserts the DTR signal at all times except during a disconnect sequence. However, there are instances when assertion of DTR is undesirable. For example, when a computer is offered as a service, the automatic reassertion of DTR after a disconnect sequence might cause the computer to act as if a session is in progress. If DTRWAIT is disabled, which is the
∙When DTRWAIT is enabled, the access server can delay the assertion of DTR until a connection is detected from a modem when an interactive user logs in or when the access server receives a connection to the port from the network.
∙With DTRWAIT enabled, the access server supports autoanswering equipment on a
∙DTRWAIT should be enabled for ports connected to computers and PCs. In order to enable DTRWAIT, you must enable MODEM CONTROL or SIGNAL CONTROL.
Enabling DTRWAIT ExampleThe following command shows how to enable DTRWAIT on port 3:
Local> CHANGE PORT 3 DTRWAIT ENABLED
Configuring Modem Signals