Huawei MG323 manual Test AT+CIND=? command, IndDescr IndValue

HUAWEI MG323 GSM M2M Module
AT Command Interface Specification	Commands for Status Control

3.2.1Querying the Supported Indication Events and Indication Status

Test AT+CIND=? command

Function Queries the supported indication events and the indication status.

Response <CR><LF>+CIND: (<indDescr>, list of supported <indvalue>s)[, (<indDesrc>, list of supported <indvalue>s)[, …]]<CR><LF>

<CR><LF>OK<CR><LF>

Parameter description

<indValue>: integer; indication event, corresponding to the value of <inddescr>.

<indDescr>: string; indication status; Table 3-1 describes the values of the parameter.

Table 3-1Values of the <indDescr> and <indValue> parameters

	<indDescr>		<indValue>
	“battchg”: battery power level		0: has not been connected to any charger.
	indicator. Currently, only the
			1: has been connected to a charger.
	value 5 is supported.
			2: being charged.
			3: The charge process is complete.
			4: The charge process is interrupted due to an error.
			5: unknown.
	“signal”: receive signal bit		0–7: correspond to the values of RXQUAL in the GSM
	error rate indicator. Currently,		05.08 section 8.2.4.
	only the value 99 is
			99: unknown.
	supported.
	“service”: network service		0: has not been registered with any network.
	status indicator.
			1: has been registered with the home network. When
			“roam”=1, the MT has been registered with another
			network.
	“sounder”: audio status		0: without ring.
	indicator, which indicates an
			1: with ring.
	event with ring. Currently,
	only the value 0 is supported.
	“message”: unread short		0: without unread short message.
	message indicator.
			1: with unread short message.
	“call”: conversation status		0: without conversation.
	indicator.
			1: ongoing conversation or conversation hold.
Issue 02 (2010-11-23)		Huawei Proprietary and Confidential		30
		Copyright © Huawei Technologies Co., Ltd.