HUAWEI MG323 GSM M2M Module

 

AT Command Interface Specification

Commands for Status Control

<disp>: integer; enables display event reporting, which is not supported currently.

0 Reports the event.

<ind>: integer; indicates event reporting.

z0 (default value): disables event reporting.

z1: enables event reporting; +CIEV:<ind>,<value>, in which <ind> indicates the event of the indicator, which is a character string.

z2: enables event reporting; +CIEV: <ind>,<value>, in which all events occur directly between the TE and TA.

<bfr>: integer; clears the buffer.

0Clears the buffer.

3.1.2Reading the Current Settings for Event Reporting

Read AT+CMER? command

Function Reads the current settings for event reporting.

Response <CR><LF>+CMER: <mode>,<keyp>,<disp>,<ind>,<bfr><CR><LF> <CR><LF>OK<CR><LF>

3.1.3 Setting the Event Reporting Mode

Write AT+CMER=[<mode>[,<keyp>[,<disp>[,<ind>[,<bfr>]]]]] command

Function Sets the event reporting mode.

Response z In case of successful execution: <CR><LF>OK<CR><LF>

zIn case of an error: <CR><LF>ERROR<CR><LF>

zIn case of an error related to the MT: <CR><LF>+CME ERROR: <err><CR><LF>

Note:

If no parameters of this command are set, AT+CMER= considers the previously set values valid for various parameters.

3.2AT+CIND - Command for Controlling Indication Events

The AT+CIND command controls the mode of reporting indication events for certain functions, including battery power level, signal strength, service availability, unread short message indicator, and full short message storage.

Issue 02 (2010-11-23)

Huawei Proprietary and Confidential

29

Copyright © Huawei Technologies Co., Ltd.

 

 

Page 46
Image 46
Huawei MG323 manual AT+CIND Command for Controlling Indication Events, Reading the Current Settings for Event Reporting