Huawei MG323 Reading the Current Indication Status, Setting Whether to Report Indication Events

HUAWEI MG323 GSM M2M Module
AT Command Interface Specification		Commands for Status Control
	<indDescr>	<indValue>
	“roam”: roaming indicator.	0: registers with the home network or does not
		register with any network.
		1: registers with the roaming network.
	“smsfull”: short message	0: The short message storage media is not full.
	storage full indicator.
		1: The short message storage media is full.
	“rssi”: receive signal strength	0: ≤ -112 dBm
	indicator.
		1–4: The strength interval is 15 dBm.
		5: ≥ -51 dBm
		99: unknown or unmeasurable.

3.2.2 Reading the Current Indication Status

Read AT+CIND? command

Function Reads the current indication status.

Response <CR><LF>+CIND: <indValue>[,<indValue>[, …]] <CR><LF> <CR><LF>OK<CR><LF>

3.2.3 Setting Whether to Report Indication Events

Write	AT+CIND=<mode>[,<mode>[,<mode>...]]
command
Function	Sets whether to report indication events.
Response	z In case of successful execution: <CR><LF>OK<CR><LF>
	z In case of an error: <CR><LF>ERROR<CR><LF>
	z In case of an error related to the MT: <CR><LF> +CME ERROR:
	<err><CR><LF>

Parameter description

<mode>: integer. This parameter controls whether to report a single indication event.

0: deregisters indication event and disables event reporting.

1 (default value): registers indication event and enables event reporting.

Issue 02 (2010-11-23)	Huawei Proprietary and Confidential	31
	Copyright © Huawei Technologies Co., Ltd.