Power supply

The power supply is accessible from the rear of the library as shown in Figure 5. These auto-ranging power supplies are capable of using any nominal ac voltage between 100 and 240 V power at 50 Hz or 60 Hz.

Power to the library is supplied through the cord on the rear panel of the power supply. Library power is controlled from the touch screen. However, a manual power disconnect switch, located on the rear of the power supply, can also be used.

Note: Only trained service personnel should remove the power supply. Hazardous voltage is present in the cavity if the power cord is removed.

1 Power on LED (lights after touching the touch screen)

2 Power supply release latch

3 Power switch

4 Power supply

5 Power cord

Figure 5. Power supply

Chapter 1. Introduction 5

Page 15
Image 15
IBM 4560SLX warranty Power supply