Figure 72. Tensioner ramp/idler pulley zero point

4.Turn the primary chassis face down.

The belt block brackets and fasteners are now visible through the access cutout.

5.Remove the four mounting screws from the two belt block brackets as shown in Figure 73.

Figure 73. Cartridge elevator belt block and brackets

6.Turn the primary chassis face up and remove the belt from the media elevator car and the tensioner ramp/idler pulley.

7.Remove the belt tensioner components as shown in Figure 74 on page 79.

a.Remove the two screws and springs from tensioner ramp/idler pulley.

b.Remove the other two screws from the tensioner ramp/idler pulley.

c.Remove the tensioner ramp/idler pulley.

784560SLX Tape Library: User’s Guide

Page 88
Image 88
IBM 4560SLX warranty Tensioner ramp/idler pulley zero point