19. Secure the timing belt with the two belt brackets and four retaining screws. If
the belt was sized properly a small space between the belt ends is visible as
shown in Figure79.
20. Remove the 0.05 in. allen wrench from the tensioner ramp.
21. Attach the bottom plate removed from the cartridge elevator in step 1 with
the retaining screws as shown in Figure80.
22. Go to “Installing the cartridge elevator”on page 72.
Module configuration
Configuring the multi-module library includes identifying which library module is
the master and which are the slaves. The module designated as the primary master
will monitor and modify the parameters and settings of the entire multi-module
cartridge elevator. The primary master can be used to perform many of the
Figure79. Timing belt to belt block
Figure80. Assembled cartridge elevator and extension
82 4560SLX TapeLibrary: User ’s Guide