
Figure 70. Cartridge elevator bottom plate
2.Slide the elevator car to the top of the primary chassis.
The elevator car is now positioned over the belt block bracket access cutout next to the PCB and drive motor.
Figure 71. Cartridge elevator media elevator car
3.On the tensioner ramp/idler pulley base of the primary chassis, compress the springs until the holes in the tensioner ramp are aligned with the holes in the base of the tensioner, and insert a 0.05 in. allen wrench through the holes as shown in Figure 72 on page 78. This sets the idler pulley to the zero position.
Appendix B. Adding a library module 77