IBM 9077 3.13 Step 5. Reset SP Switch Router System to Install Files, 3.13.1 Saving Configuration Files

Installation and Configur ation 96
Nevertheless, check the file /etc/grdev1.conf. It must contain an entry for the
slot in which the media card is installed. As we have our card in slot 3, the
entry looks as follows:
These entries show up after the SP Switch Router Adapter card gets
configured on the SP Switch.
3.13 Step 5. Reset SP Switch Router System to Install Files
To install the system configuration fil es, first save the files and then reboot the
SP Switch Router.
Save the files after you complete changing the system parameters, and again
after you configure the media cards and any network services, such as
filtering or dynamic routing, using grwrite -v. To check if any files need to be
written to permanent storage, use grwrite -vn.
Note: grwrite only saves files in the /etc directory. If you changed files in
different directories, use grsite and grsite --perm, respectively.
Use reboot -i to reset the system.
3.13.1 Saving Configuration Files
Use the grwrite -v command to save the configuration files in the /etc
directory from RAM to a flash device. This preserves the configuration files
over a reboot.
# CARD 3 Interface 0
#
2.21.4.1.1.1 "03" # Node N ame
2.21.4.1.1.2 4 # Node N umber
2.21.4.1.1.3 "00:00 :00:01:00 :00:00:06 :00:01" # Swit ch Token
2.21.4.1.1.4 2 # Switch ARP
2.21.4.1.1.5 3 # Switch Node Number
2.21.4.1.1.6 x192.1 68.14.4 # IP Add ress
2.21.4.1.1.7 x255.2 55.255.0 # Net Ma sk
2.21.4.1.1.8 1024 # Max Li nk Pck t Len.(by tes)
2.21.4.1.1.9 1 # IP Hos t Offs et
2.21.4.1.1.10 1 # Config uratio n State
2.21.4.1.1.11 sp21en 0 # System Name
2.21.4.1.1.12 2 # Node S tate
2.21.4.1.1.13 1 # Switch Chip Link
2.21.4.1.1.14 31 # Node D elay
2.21.4.1.1.15 1 # Admin Status
#