IBM 9077 manual Procedure to Get the Jack Number, Node Numbering for an SP System

15	16	31	47	61
13	14	29	45
11	12	27	43	57
9	10	25	41
7	8	23	39	53
5	6	21	37
3	4	19	35	49
1	2	17	33
Switch 1		Switch 2		Switch 3
Frame 1		Frame 2	Frame 3	Frame 4

Figure 33. Node Numbering for an SP System

3.5.2 Procedure to Get the Jack Number

Following are the steps required to get the jack number:

1.From the SP control workstation, determine the dependent node’s number by entering SDRGetObjects DependentNode node_number. This produces output that looks like the following:

#SDRGetObjects DependentNode node_number node_number

4

2.From the SP CWS, determine the switch_node_number by entering

SDRGetObjects DependentNode node_number==n switch_node_number, where n is the node_number of the dependent node you just got from the previous command. This gives the following output:

#SDRGetObjects DependentNode node_number==4 switch_node_number

switch_node_number 3

#

3.From the SP CWS, determine the host name of the SP Switch primary node by entering splstdata -s grep -p primary. The output looks like this:

Installation and Configuration 84