IBM RS/6000 manual Model H Series Installation and Service. Guide

Service	Aid	Error	Codes
If	the	SSA	service aids detect an unrecoverable	error and are u
one	of	the	following error codes might occur:
SSA01		Not	enough using-system memory is available	for this service
		tinue. Take one of the actions described		here:

Ÿ This	problem	might be caused by a failed application pr
the	user to	end any failed application program, then tr
service aid		again.

ŸRun diagnostics in the problem determination mode on the

	unit. If		you	find	any problems,		solve them;	then	try	to
	aid	again.
Ÿ	Close	down and reboot the using					system; then try		to	run
	aid	again.
Ÿ	Run	diagnostics		from	diskette	or	CD-ROM to isolate the pr
	you	do	not find a		problem,	the	operating	system	might h

SSA02 An unknown error has occurred. Take one of the actions desc

ŸRun diagnostics in the problem determination mode to the

unit.	If you find any problems, solve them; then try to
aid	again.

ŸIf diagnostics fail or if the same problem occurs when service aid again, run the diagnostics from diskette or isolate the problem. If you do not find a problem, the system might have failed.

SSA03 The service aid was unable to open an hdisk. This problem m occurred because a disk drive module has failed or has from the system. Take the actions described here:

1.Use the Configuration Verification service aid (see “Con ification Service Aid” on page 7-41) to determine the loc the SSA adapter to which the hdisk is attached. (For e location code of the hdisk is 00-03-L, the location code adapter is 00-03.)

2.Run the Link Verification service aid (see “Link Verific

Aid” on page 7-38)to the SSA adapter.

3.If a link failure is indicated by the service aid, g nance Analysis Procedures (MAPS)”RS/6000in Enterprise Server

Model H Series Installation and Service. Guide

4.If no link failures are indicated, run the diagnostics ification mode to each pdisk that is attached to the

Chapter 7. Using the Service7-47Aids